So at the moment my type RS is sitting at the rotary mans workshop here in townsville waiting to get the engine block rebuilt and diagnosed for why the front rotor has lost compression.
So far my plan is to keep the car and have the engine rebuilt and get my os giken differential installed so i can finally drive the shit out of it without fear of it dying again... But reality is harsh and unfortunately depending how much cost is racked up getting it to the awesome state that its been built up to, I may just be forced to sell the car and frankly after 8 years of ownership i think it may be time to let it go if the bill gets too high so for now this sale is EOI only to see what its worth and what the market for modded rx7's is like so for now ill show some old pictures and list its comprehensive modifications.
NOTE: ENGINE WILL BE FRESHLY REBUILT AND RUNNING WELL WHEN (and if) CAR IS SOLD
Car:2000 type rs, Innocent blue mica
Wheels: 5zigen 5no1rc , 17x8 front +35 offset, 17x9 rear +43 offset
Tyres: Brand New Yokohama advan AD08R tyres in the standard FD 17 inch tyre sizes.
Brakes: Standard type RS rotors with QFM high friction brake pads, Hel braided brakes lines, cusco master cylinder stopper.
Suspension:MCA red type coilover suspension 14kg front springs, 8kg rear springs, custom valved for street use with occasional track work.
Body Bracing: James group buy differential brace, Re amemiya front swaybar mount cross engine brace, cusco carbon front strut brace, standard oem rear strut brace.
Interior: Rare Mazda type RSR momo steering wheel, Defi gauge cluster with water,oil temp and oil pressure gauge, Defi boost gauge, Knightsports 305km/h speedometer, Drivers side seat rail modified to go back further than standard.
ENGINE: Freshly rebuilt and extend port motor, race bearings, oil pump O ring machined into mounting face, secret squirrel apex seals, xcessive manufacturing engine mounts, Xtreme rotaries pulley kit.
Intake: Xcessive manufacturing lower intake manifold, lightly honed and port matched to intakes, Oem upper intake manifold with double butterflies removed and modified for single turbo use,Knight sports enlarged throttle body, completely hand built alloy stainless steel breather and oil catch can system.
Cooling:Greddy Vmount intercooler kit with radiator and air ducting, R Magic Coolant filler neck, Air separator tank deleted.
Ignition:Standard oem coils, Ngk sparkplug leads, HKS Twin power unit
Turbo/intake/exhaust: Turblown hand welded stainless turbo kit with hard lines, borgwarner efr 7670 turbo with .92 exhaust housing internally gate, 3 inch turblown dump pipe, smb 3 inch catalytic converter, unknown brand Jasma standard 3 inch cat back, Fuck off big aeroflow airfilter with custom intake pipes, aeroflow hose joiners.
ECU:Haltech elite 2500 ecu, Haltech wide band system, Haltech elite patch loom for series 8's, Twin bosch knock sensors.
Fuel system: Walbro 400lph fuel pump, RS engineering anti surge fuel cover for factory internal surge tank, turbo smart fpr 1200 fuel pressure regulator with gauge, Full function engineering primary fuel rail with spacers, 550cc primary fuel injectors, 2000cc Bosch secondary injectors.
Other: ADR approved fiberglass bonnet from Blits group buy, looks like the mazdaspeed rspec bonnet, Battery is a 350cca compact battery from SSB.
And here's ^^^ an engine bay picture.