FD3S Rear "Euro" Washer / Fluid Tank

[MattGold]

Done! Thanks for looking after the international customers Matt. I'll be purchasing mine tonight

Thanks so much. We're actually taking a loss on some countries - but it's in the interest of keeping it simple and accessible for all.


ALSO... a note for people on the fence. The current Group Buy price is only going until August 15th, after that, the price jump $120 and shipping goes back to "normal" (read: higher). So NOW is the time to order, don't wait.





TELL YOUR FRIENDS!

[SakeBomb Garage]

Just a reminder! Last Days for pre-orders!




http://www.sakebombgarage.com/trunk-...njection-tank/

[MattGold]

Been a while - but figured we should follow up with this.


The first production tanks are being installed! Install is about as close to OEM as it gets.






SakeBomb ALSO developed an awesome Bracket for installing the pump on the underside of the vehicle, which in turn uses the same routing as the stock fuel lines:







We have ALSO shipped the initial run of tanks!







That was an adventure. We loaded an obscene amount of tanks in an extremely short amount of time. So many, that we had to request a one ton USPS trunk to handle it all - and the FILLED it!

So that means, if you ordered a tank it’s en route. There are some exceptions on tank/bracket combos as we’re awaiting some hardware - but those will go out early next week.

I believe we had about a dozen going to Australia/New Zealand. BUT if there are any of you that didn't get on the initial bandwagon - SakeBomb Garage is extending FREE International shipping using the coupon code:


'tankintfreeshipping'.


HUGE thanks to Alex, Brian, Christian, Heath and Travis over at SakeBomb Garage for their hardwork, hospitality and patience getting this project from concept to reality.

[gav240z]

That's awesome!

[Clarke86]

Cheers matt and sakebomb. Mine was delivered today.

Its definately I well made and sturdy bit of kit.

Still waiting on the pump mount bracket. Any idea when these will be shipped? I was under the impression it was all coming together

[MattGold]

Cheers matt and sakebomb. Mine was delivered today.

Its definately I well made and sturdy bit of kit.

Still waiting on the pump mount bracket. Any idea when these will be shipped? I was under the impression it was all coming together

Yeah, it should have been. Probably got caught up in the "get it out the door" rush.


PM me your info (order #, name, address, etc).

[Re7]

thanks Matt/ Heath - got mine, did i quick fill check to ensure no leaks - all good baby. the aquamist sys finally "complete" (and still not installed)...ffaaarrk

[MattGold]

thanks Matt/ Heath - got mine, did i quick fill check to ensure no leaks - all good baby. the aquamist sys finally "complete" (and still not installed)...ffaaarrk

GREAT news! Now get that baby installed!

[fd al]

Hi Matt, bumping up and old thread. im chasing one of your tanks for my fd rx7. Any specials on these tanks with post to Australia. Thxs Allan